Pump, Wavemaster 5000 Replacement

Item #: 02110005-1010
$484.86

This 1.0 HP FMHP series pump replaces the obsolete Wavemaster® 5000 found on the pre-1997 Hot Spring and Tiger River spa models and will only work on tubs wired for 230v.

  • Add 2 Compression Fitting O-rings?

  • Include Barbed Fitting? (32267):

  • Include Barbed Fitting? (33732):

View OEM
SKU: 02110005-1010 Categories: , Tags: , , ,

Description

What’s Included: Pump, two compression fittings with o-rings. **NO VENT SHROUD or POWER CORD**
Specs: 1.5 HP (1.0 HP* Operational HP), 2 Speed, 60 Hz, 48 Frame, 230-volt, 1 1/2″ intake/discharge.
Power Cord: No power cord is included with this pump. One can be purchased/installed at an additional fee or you can re-use your power cord.
Vent Shroud: Per the manufacturer, this pump is designed to be air-cooled and does not need a shroud. You may, however, use your existing shroud.

Description: This replaces the obsolete Wavemaster® 5000 one-horsepower, one-speed pump found on the pre-1997 Hot Spring and Tiger River spa models and will only work on tubs wired for 230v. The obsoleted pump (33980) was a convertible pump. This pump is NOT CONVERTIBLE. For the 115v, use 34677.
Note: This pump does not include the pump shroud or the power cord. And while the pump can be operated without a shroud (per the pump manufacturer), your existing shroud your existing pump (if equipped) can be installed on this new pump. This pump is dual-speed and when using a dual-speed pump in place of a single-speed pump, leave the low-speed wire disconnected. You will hook up only the high-speed wire of the pump to your control box. The low speed will not be used.

Important information for replacement parts:
Please check the model number and markings on your wet end before selecting replacement parts.

After-Market 33980-BYP
Model: 02110005-1010
Wet End Impeller Shaft Seal Wear Ring
33980-WETEND* 70457** 71447-BYP 70220

*Stamped on volute: 92770501A. Stamped on suction cover: 9123130.
**70457 Dots: orange (use 70220 wear ring)
If you can’t determine the dots on your impeller, buy the entire wet-end kit. The installation time is about the same.

View compatibility table & diagrams

You may also like…

  • Pump, Wavemaster 3000/5000
    This Wavemaster® 3000/5000 is a 115v jet pump is the current replacement for the 1993-2002 Hot Spot Round, Hot Spot RE and 1995-2000 Hot Spot2 and Hot Spot SE spa models Also the replacement for the 1990-1996 Hot Spring Jetsetter and Prodigy and the 3rd ...read more
    $473.47 View Generic
    Add to cart