🌟 🌟 🌟 🌟 🌟 Absolutely the best customer service. Highly recommend.On 02/15/2024 by R. P. (verified customer)
Showing 61–90 of 246 results
-
This wiring harness connects the electronic thermostat to the PWA Board on the backside of the 1995-1996 Tiger River Control Panel If there is a communication problem with this wiring harness there will be erratic heating issues in a 1995-1996 Tiger River ...read more -
The jet switch is located in the control box of all 1995-1998 Hot Spot spa models It is connected with a clear vinyl tube to the air button located on the bartop of the Hot Spot models Once the air button is depressed a puff of air activates this switch In ...read more
-
Cable connector assembly for Khyber -
Sku: 31394
Control Panel-Winterizing Plug
Control panel winterizing plug -
Sku: 20356
Jet Button with spring, Hot Spring
Control panel jet button found on the 1988-1993 Hot Spring spas front control panel This button presses on the jet switch, located behind the control panel and inside of the main control box This button comes in this darker gray color and a light gray color ...read more -
Sku: 71986
Rj-12 Phone Connector, 25 Pack
25 Pack of the connectors that go on the end of the cable for the replacement aux panels for spas made beginning in 1998 -
Sku: 74079
Navigator Remote Control Ferrite Magnet
Ferrite magnet used to prevent interference on the Navigator Remote control for the IQ2020 control system One of these is installed on each of the communication cables for any accessories used in the spa if there is a problem with the wireless remote ...read more -
Sku: 73739
Navigator Battery Plug
This is the plug used to secure the AA Batteries into the Navigator Remote Control It screws into the bottom of the Navigator by fitting a coin into the slot and using the coin to grip the plug -
Sku: 73232
Butterdish Kit, Hot Spring Aux Panel
This butter dish houses the Auxiliary Control Panels in all 2004-2013 Hot Spring models (except Jetsetter) For 1998-2003 spas you'll need 71496 The butter dish is rarely replaced Replacement requires removing the exterior synthetic wood siding then digging ...read more -
Sku: 73159
Navigator Bracket
This is the plastic holder that can be mounted using two self tapping screws to virtually any surface like the side of the spa, or a post or wall inside indoors, to hold the Navigator Remote Control -
This rotating jet switch is located in the control box of some pre-1989 Hot Spring spa models It is activated by rotating the "Jets" dial on the exterior control panel
-
This rotating jet switch is located in the control box of some pre-1989 Hot Spring spa models It is activated by rotating the "Jets" dial on the exterior control panel
-
Sku: 70829
Pushbutton Assembly, Cleanup Cycle-White
Clean cycle pushbutton assembly in white -
Sku: 70828
Pushbutton Assembly, Light Gray, Classic
Pushbutton assembly in light gray color for Classic models This button is used to turn on jets and other functions on older Hot Spring Classics -
Sku: 70724
Tempurature Knob Assembly, White
Replacement knob assembly for the adjustment of the temperature of the spa for Hotsprings Classic model spas built from 1994 to 1997 with white control panels Knob connects to a standoff connected to the thermostat inside the spa control box -
Sku: 70675
Pushbutton Assembly Jet 2
This jet push button assembly is used on Hotsprings spas with two jet pumps made between 1993 and 1997 This jet button is marked "Jet 2" to notate that it will activate the second jet pump when pressed -
Sku: 70422
Knob Assembly, Light, Light Gray Color
This knob is a component of the control panel for all Hotsprings spas made from 1989 to 1993 It is the control knob for the dimmer for the spa light It is included with a complete control panel -
Sku: 70421
Thermostat Knob Assembly, Light Gray
Replacement thermostat knob in light grey color for adjusting the temperature on Hot Springs spas with light grey control panels built from 1988 to 1993 This knob connects to a standoff attached to the thermostat in the control box -
Sku: 36936
Light Knob, Dark Gray
Replacement knob in dark grey for adjustment of the brightness of the spa light This was used on Hotsprings spas in 1997 with dark grey control panels Knob connects to the light dimmer built into the spa control panel -
Sku: 36546
Temperature Knob, Hot Spot
This black round knob is used to dial the temperature up or down on all 1993-1997 Hot Spot spa models -
Sku: 35106
Control Panel Housing, Tiger River
This plastic housing (plate) is found on all 1993-1997 Tiger River Control Panels It is the base piece that houses the jet & light buttons and temp dial -
This label is used on all 1992-1996 Tiger River topside control panels This can be used as a replacement if the label on the topside is marred or peels off Simply peel off the old label after removing the thermostat knob and jet push buttons, and stick ...read more
-
Sku: 35101
Temperature Dial, Tiger River
This gray-colored temperature (thermostat dial) dial is found on all 1993-1997 Tiger River spa top-side control panels -
Sku: 35099
Adapter, T-Stat Knob
This adapter was used from 1992 to 1997 on all Tiger River topside control panels The adapter accepts the decorative knob that is turned to adjust the temperature and connects to the actual thermostat, which adjusts the thermostat when the knob is turned -
Sku: 35087
Standoff, Control Panel 1995-1997
This standoff is used to position the control panel circuit board apart from each other on all 1995-1997 Tiger River spa models -
Sku: 34412
Control Panel Light Knob, White
This knob is a replacement for the light dimmer knob used on the Hotsprings Classic spa with the white version of the control panel, built from 1994 to 1997 Knob attaches to the standoff on the dimmer to adjust the brightness of the spa light -
Phillip head stainless steel screw, 8-18 x 3/8in for control panels on Hot Spring models 1994-1997
-
Sku: 34301
Lens, Cleanup Cycle Light
Clear round lens inserts into the front control panel on all 1994-1997 Hot Spring spa models It is illuminated by the red L E D light behind it -
Sku: 33863
Clamp, Control Panel, Tiger River
This clamp attaches to the back side of the 1992-1997 Tiger River topside control with a screw, and when tightened, holds the topside down to the shell of the spa An o-ring is used between the topside and the shell, which is compressed by the clamp pulling ...read more -
Sku: 33859
Bezel, Control Panel, Tiger River
This bezel serves two purposes Used on all Tiger River Models from 1992 - 1997, it finishes off the edge around the jets and lights buttons on the control panel for aesthetics, as well as secures the button in place to prevent the button from popping out ...read more
Showing 61–90 of 246 results