Great serviceOn 04/19/2024 by H. P. (verified customer)
Showing all 11 results
-
Heater connection wire kit, 8" long, 10 gauge wire, qty of 2 Connects from Hot Spot heater to board of S-Class series control box
-
Grounding bar for the Hot Spot heater (after-market Gecko S-Class) 5 Position, 14-6 AWG This grounding bar is attached to the heater on Hot Spot and Solana brand spas and allows the pump and other accessories to have a secondary ground tied into the ...read more
-
This Hot Spot heater electronic pressure switch is a safety device that will shut down the heater if a "low water flow" condition occurs It is used on Hot Spot models (except Sprint & Dash models) and Solana spa models Some symptoms of failure include ...read more
-
This heavy-duty fiberglass-reinforced polymer split nut comes in two pieces and is designed to replace compression fitting nuts (aka pump union nuts) that have broken due to vibration, age and finally over-tightening The two halves of this fitting are held ...read more
-
This plug has been used on the 220volt pre-1995 Hot Spring heater to cap off the drain hose by clamping the 1/4" vinyl drain tubing to the closed 1/4" nipple on this plug Also used in the 71557-BYP Kit
-
This replacement compression fitting split nut (AKA Split Union Nut-2") is used to connect heaters on the 1993-1994 Hot Spot Z, all 1998-current Hot Spot models, Solana models beginning in 2000 and all 1992-1994 Tiger River spas It is designed in two half ...read more
-
Sku: 70905
Heater Tailpiece, Hot Spot and Solana
This heater tailpiece glues into the plumbing on one end and the threaded end is coupled with the compression nut of the heater on a 1993-1994 Hot Spot Z, all 1998-2002 Hot Spot models, and all 2000-current Solana spa models The heaters have a compression ...read more -
Sku: 37726
Heater Housing Tail Piece, 2in x 1 1/2in
This is a heater tailpiece for a 2-inch heater housing The tailpiece is designed to accept a 1 1/2" PVC pipe or a 1 1/2" male PVC fitting The connection should be made using PVC cement and primer -
Obsolete: Use 1642001-1 This heater tailpiece glues to 2" PVC pipe or a 2" male PVC fitting using PVC primer and cement The threaded side of the fitting will connect to any 2" standard heater union to connect a flow-through type heater This specific ...read more
-
Sku: 10066
Thermometer
No Longer Available Thermometer
Showing all 11 results