Good company. Honest. ThanksOn 06/03/2024 by D. S. (verified customer)
In our lineup of over 3100 genuine Hot Spring spa parts are all four designs of the Hot Spring brand of cover lifters. Some of these cover lifters or Retractable Cover Systems (RCS) are designed to attach to the spa and also to the Hot Spring cover. In 1996, all Hot Spring spa covers (Watkins) were equipped with hidden steel inserts embedded into the insulated foam cores. These inserts enabled some styles of Hot Spring cover lifters to attach directly into the edge of their spa covers. Mega beefy design!
Showing all 12 results
-
Sku: 37876
Uprite Cover Lifter (7in Clearance)
The Uprite® Lifter is a favorite for close clearance needs If your spa needs to be nudged up close to the house, fence or gazebo then this lifter is ideal The Uprite® (sometimes spelled upright) only requires seven inches (7") of rear clearance to ...read more -
Sku: 71794
Gas Spring-Uprite
The Uprite® Cover Lifter employs two gas shocks that assist in opening the spa cover Sometimes these gas shocks can fall victim to the elements (storms, crazy uncles, frat parties etc ) and need replacing Replacement time is approximately thirty seconds ...read more -
There were two different sized ball studs used on Hot Spring cover lifters One is this 1/4" threaded shaft and the other (3rd qtr 2009) is 5/16" threaded shaft (part 75149) Either one size or the other will be on your cover lifter but not both sizes Ball ...read more
-
Sku: 75103
Gas Spring Lock-Uprite
The Gas Spring lock is used to secure the Uprite Lifter in the open position attaching to only one gas shock This part is typically left off when installing the Uprite Cover Lifter unless the spa is located in a windy area -
This ball stud is found on 3rd quarter 2009 and newer UpRite, Cover Cradle and Cover Cradle II lifters The older cover lifters used a 1/4" threaded shaft ball stud which is part# 71107-BYP
-
Sku: 71793
Angle Bracket-Uprite
Angle bracket for Uprite cover lifter -
This part attaches onto the right side of the spa cover
-
Sku: 73451
Hardware Bag #1, Uprite Cover Lifter
Bag #1 for the upright cover lifter Contains the following: 2 x 1/4 x 20 5/8" Hex Bolts 2 x 1/4 x 1" Fender Washers 2 x 2 Hold Deck Hinge 10 x #10 Washers 8 x #10 1/2" Square Panhead Self Tapping Screws 10 x #10 1 1/2" Square Pan Tapping Screws 12 ...read more -
Right side bracket (as you are facing the spa folding the cover away from you) for the Uprite cover lifter
-
Sku: 71789
Upright Side Bracket Assembly, Left Side
Left side bracket (as you are facing the spa folding the cover away from you) of the Uprite cover lifter -
Sku: 75152
Upright Extension Tube
One pair (quantity of two) of extensions for the Uprite cover lifter -
Sku: 75150
Uprite Channel Pivot Assembly, Left Side
This part attaches onto the left side of the spa cover
Showing all 12 results