Hardware

Hardware: Clamp, Fastener, Screw Cover

Showing all 16 results

  • Spring Clamp, 3/4 inch
    3/4" spring clamp (aka wire clamp) is used to secure the 3/4 inch vinyl tubing (70315) to various components Note: Wear eye protection when squeezing these little rascals Service techs typically use either needle-nose pliers or hose clamp pliers to ...read more
    $1.22
    Add to cart
  • Spring Clamp, 1/4in
    Used to secure 1/4" (ID) vinyl tubing 70318 (OD measure 7/16") to various components Note: Wear eye protection when squeezing these little rascals Service techs typically use either needle-nose pliers or hose clamp pliers to squeeze, then slide this ...read more
    $1.02
    Add to cart
  • Spring Clamp, 1/2in
    1/2" spring clamp for securing 1/2" ID vinyl tubing (70316) to components Item 70316 has an inner diameter of 1/2" and an outer diameter of 3/4" This clamp fits the 3/4" OD Note: Wear eye protection when squeezing these little rascals Service techs ...read more
    $1.19
    Add to cart
  • Spring Clamp, 3/8in
    3/8" spring clamp (aka wire clamp) is used to secure the 3/8 inch vinyl tubing 70317 (9/16" OD) to various components Note: Wear eye protection when squeezing these little rascals Service techs typically use either needle-nose pliers are hose clamp ...read more
    $1.27
    Add to cart
  • Equipment Door Fastener, Male Piece
    This pointed fastener attaches onto the equipment compartment access door and is inserted into its counter-part fastener that is attached to the door frame of the equipment compartment
    $1.74
    Add to cart
  • Screw Cover Cream
    Six of these screw covers are used to hold the equipment door in place on the Hot Spot TX from 2005 to 2010   These cream-colored caps attach to a plastic retainer that surrounds the head of the screw used to hold the door panel in place to provide a more ...read more
    $7.14
    Add to cart
  • Spring Clamp, 1in
    1" spring clamp (wire clamp) used to secure 1" vinyl tubing
    $1.52
    Add to cart
  • Screw Cover, Equipment Door, TX, Taupe
    Six of these round screw covers are used on the Solana TX made from 2000-2004 to hold the equipment door in place   These taupe-colored caps attach to a plastic retainer that surrounds the head of the screw used to hold the door panel in place to provide a ...read more
    $13.72
    Add to cart
  • Impeller Screw, 1/4in, Starite P/N C30-12
    This fastener screws onto the top of the equipment compartment door frame and serves as an alignment for the male fastener
    $1.74
    Add to cart
  • Impeller Screw, 1/4in, Starite P/N C30-12
    Fasteners used to hold the housing for the LED light assembly in place on Hotsprings, Tiger River, and Limelight spas These are included if you purchase a replacement light assembly
    $19.55
    Add to cart
  • Romex Clamp 3/4in
    This clamp is used as strain relief is used to secure the heater's power cord to the bottom of the IQ Control box The strain relief prevents the cord from accidentally being disconnected from inside the control box should the cord be pulled down
    $3.68
    Add to cart
  • Screw Cap, Black set of 10
    CAP, SCREW BLACK 10/SET RTA
    $6.27
    Add to cart
  • Snap Clamp Snp #6
    OBSOLETE:  Use 31134 This is a #6 size snap clamp used on 1/4" vinyl tubing   Snap Clamp (Min Dia In ) 0 449 / (Max Dia In ) 0 511
  • Romex Clamp 3/8in
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Romex Clamp 3/8in
  • Romex Clamp, #88
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Romex Clamp, #88
  • Screw Cover, Gray, Dream Pillow
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com The screw covers hide the five stainless steel screws that hold the Dream Pillow in place This item is ...read more

Showing all 16 results