PLUMBING

Find all the plumbing parts you need here. Flexi PVC tubing, Vinyl Tubing, Elbows, Tees, Diverter Valves, Levers & Bezels, Check-Valves, Couplers, and more.

Plumbing: Cap, Check Valve, Compression Fitting, Plug, Tubing

Showing 1–30 of 84 results

  • Vinyl Tubing, Thick Walled, 3/8in Inside Diameter x 36in
    3/8" inside diameter (ID) by 36" long section of specially made thick-walled, clear vinyl tubing This thick-walled tubing will stand up to the harsh chlorinated spa environment for years to come Measures 3/8" ID; 9/16" OD Uses 34465 spring clamp 3/4" ...read more
    $7.95
    Add to cart
  • Tubing Kit, Del-Ozone-1/4in with Check valve
    This 1/4" ID (3/8" OD)  ozone-resistant tubing works with UO3 ozone generator It includes an attached 1/4" ozone-resistant check valve, clamps, mounting screws, and new flag terminals This assembly is approx five feet in length Note: There is a small ...read more
    $20.12 View OEM
    Add to cart
  • Tubing Kit, Freshwater III Ozonator-1/4in Tygon/Kynar with Check valve
    This 1/4" ID (3/8" OD) Kynar/Tygon ozone-resistant tubing kit comes standard with the Freshwater III Ozonators It is the replacement for all Freshwater 3 ozonators It includes an attached 1/4" ozone-resistant check valve This assembly is approx six feet ...read more
    $55.00 View Generic
    Add to cart
  • Water Check Valve, 3/4 inch
    This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the backflow of water through the circulation pump once the jet pump is activated All water check valves have arrows stamped on the outside to indicate ...read more
    $8.25
    Add to cart
  • Check Valve (Air), Hot Spring, Tiger River, Limelight, Hot Spot
    Air check valve for Hot Spring, Tiger River, and Hot Spot spa models This check valve is located in the equipment compartment under the bartop Its primary function is to prevent water from back flowing into the equipment compartment should a hydrotherapy ...read more
    $20.09
    Add to cart
  • Cap, Drain Valve - 3/4in with Washer
    Black 3/4" hose bib thread cap used on the drains of 1993 forward Hot Spring, Tiger River, Hot Spot, and Solana, and Limelight spa models   It also includes the washer   This cap is used both on the "Primary" Drain Valve, and the "Secondary" Drain Valve
    $1.70
    Add to cart
  • Compression Fitting O-rings, for 2 inch Union (Qty of 2)
    (Quantity of 2 o-rings) O-rings used on the pumps 2" compression fittings ( 71036 ) found on most Hot Spring, Tiger River, Limelight, Hot Spot and Solana spa models Also used on the replacement "Wet End" pump kits and some heaters The 2" measurement refers ...read more
    $3.42
    Add to cart
  • Compression Fitting O-ring, for 2 inch Union
    O-ring used on the 2" compression fittings (71036) on most Hot Spring, Tiger River, Hot Spot, and Solana spa models The 2" measurement refers to the inner diameter of the most narrow part of the compression fitting/union The o-ring that is included measures ...read more
    $1.80
    Add to cart
  • Compression Fitting, 2in with O-Ring
    This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction side of most Wavemaster® XP2 or XP2e Series Jet Pumps Other compression fittings are the 71038 and 71037 ...read more
    $12.99
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $6.36
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $3.26
    Add to cart
  • Compression Fitting, 1-1/2in with O-Ring
    This 1-1/2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction and/or discharge side of FMHP/CP Series Wavemaster® Jet Pumps 2" x 1-1/2" Compression Fitting click ...read more
    $9.86
    Add to cart
  • Manifold, Flow Cone
    This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling 1-1/2" Compression Fitting 2" Compression Fitting
    $12.78
    Add to cart
  • Drain Plug, Wavemaster
    This drain plug is screwed into the female port on the front of Wavemaster 3000, Wavemaster 4000 and 6000 jet pumps when there is an absence of a bleedline   For spas with a bleedline, the 32267 is used in place of this fitting This drain plug can be ...read more
    $2.93
    Add to cart
  • Check Valve, Air, with Ball 1/2in
    It is used to prevent water from backing into the airlines when the jets are off It is at the back of the Moto-Massage housing and glued into a 90-degree elbow It is also on the jetstream jets
    $1.74
    Add to cart
  • Check Valve (Ozone) Freshwater Ozone, 1/4in O.D.
    Over time an Ozonator check valve will breakdown under the harsh conditions of ozone Our OEM check valves have a special diaphragm (Viton) that enables them to last longer than rubber Rubber diaphragms last about a month before the rubber becomes hard
    $19.53
    Add to cart
  • Manifold Plug, 3/4in Slip X 1/4in closed nipple
    This plug has been used on the 220volt pre-1995 Hot Spring heater to cap off the drain hose by clamping the 1/4" vinyl drain tubing to the closed 1/4" nipple on this plug Also used in the 71557-BYP Kit
    $10.96
    Add to cart
  • Cap, Air Control, Jet Selector, Gray
    This gray cap fits on the top of the air control lever to hide the stainless steel screw This cap is also used on the water diverter levers (Smart Jet Selector) white on white spas and gray on all other colored spa shells
    $1.52
    Add to cart
  • Cap, Air Control/Jet Selector, White
    This white cap fits on the top of the 1993-2003 Hot Spring Comfort Control air lever to identify it as the Comfort Control Lever for the Moto-Massage Jet on white-colored Hot Spring models only Note: Also used as an upgrade for the colored dots (sticker) ...read more
    $6.84
    Add to cart
  • Flexible PVC, 3/4in Inside Dimension X 3ft
    Flexible PVC is a ribbed looking white or beige type of PVC It comes in three-foot sections and is glued using PVC primer and PVC cement found at your local hardware store The diameter is measured from the inside (I D ) of the piping Note: This is ...read more
    $13.18
    Add to cart
  • 449-020 2in Plug
    This is a 2" PVC plug   It can be used to plug any 2" female PVC fitting and should be installed using PVC primer and cement   You can get PVC cement at your local hardware store
    $4.69
    Add to cart
  • Flexible PVC, 2in inside Diamter X 3ft
    Flexible PVC is a ribbed looking white or beige type of PVC This size is usually found coming off of the jet pump or water diverter valves (Smart Jet) It comes in three-foot sections and is glued using PVC primer and PVC cement found at your local hardware ...read more
    $32.85
    Add to cart
  • Air Check Valve Tiger River and Hot Spring Pre-1997
    This air check valve is located in the equipment compartment, up high, under the bar top If a hydrotherapy jet should become obstructed (like when a guest sticks their finger in the jet), this item becomes critical in preventing water from back flowing into ...read more
    $24.28
    Add to cart
  • Flexible PVC, 1/2" inside Diameter X 3ft
    Flexible pvc is a ribbed looking white or beige type of pvc It comes in three foot sections and is glued using pvc primer and pvc cement found at your local hardware store The diameter is measure from the inside (I D ) of the piping Note: This is ...read more
    $11.66
    Add to cart
  • Hartford Loop Assembly
    This retrofit kit is used to replace the air check valve that was used in some Hot Spring spa models This kit replaces the obsolete 72342 Check your serial number in the parts finder above to be sure this part is for your spa
    $71.07
    Add to cart
  • Water Check Valve, 1-1/2" Inside Diameter, 2in Outside Diameter
    This "Jet System" check valve is used on all Hot Spring models and all Tiger River spas This check valve engages when the diverter valve is changed to different positions For convenience, the inside diameter of this check valve is 1-1/2" and the outside ...read more
    $29.48
    Add to cart
  • Flexible PVC,1-1/2in Inside Diameter X 3ft
    Flexible PVC is a ribbed looking white or beige type of PVC This size is usually found coming off of the jet pump or water diverter valves (Smart Jet) It comes in three-foot sections and is glued using PVC primer and PVC cement found at your local hardware ...read more
    $28.35
    Add to cart
  • Compression Fitting Split Nut, Heater, 2in
    This replacement compression fitting split nut (AKA Split Union Nut-2") is used to connect heaters on the 1993-1994 Hot Spot Z, all 1998-current Hot Spot models, Solana models beginning in 2000 and all 1992-1994 Tiger River spas It is designed in two half ...read more
    $8.86
    Add to cart
  • Tubing Kit, Freshwater III Ozonator-1/4in Tygon/Kynar
    This 1/4" ID (3/8" OD) Kynar/Tygon ozone-resistant tubing kit comes standard with the Freshwater III Ozonators and is also the current replacement tubing for all Freshwater III units   Note:  Tubing only
    $41.58
    Add to cart
  • Flexible PVC, 1in Inside Diameter X 3ft
    Flexible PVC is a ribbed looking white or beige type of PVC It comes in three-foot sections and is glued using PVC primer and PVC cement found at your local hardware store The diameter is measured from the inside (I D ) of the piping Note: This is ...read more
    $12.64
    Add to cart

Showing 1–30 of 84 results