I would like to express how excellent this company is. I inherited a house with a 2007 Hotspring Aria hot tub. The spa hasn’t been operated in years and when I turned it on, it ran for about 10 minutes and died. I mean dead died. I knew absolutely nothing about hot tubs but with the excellent diagnosis videos, installation videos and superior phone support, I was able to replace the main control board, heater relay board, heater, circulation pump, the ozonator and all associated tubing. This took 4 1/2 hours over two days (I had to watch videos) but the spa runs like new! I had one question regarding the jumper voltage 18 or 12. I spoke with a technician and he was able to answer my question as well as helping me double check the voltages for the components on the relay board. I am handy with electronics and electricity and am comfortable working with 230 volts. Shipping was fast and as expected. I highly recommend BackYardPlus.On 06/28/2024 by F. R. (verified customer)
Find all the plumbing parts you need here. Flexi PVC tubing, Vinyl Tubing, Elbows, Tees, Diverter Valves, Levers & Bezels, Check-Valves, Couplers, and more.
Showing 1–30 of 63 results
-
Sku: 34350
Diverter Valve Snap Ring
This snap ring is used on most of the diverter valves on Hot Spring & Tiger River spas A special snap ring tool is needed to remove this part -
Sku: 36160
Precision Jet Tee
This tee is used to glue onto the rear of the Precision Jet Body and provides a 1/2" connection on either side of the tee This tee is not available at the local hardware store -
Sku: 73920
Water Feature On-Off Valve Assembly
This on-off valve assembly is found on Hot Spot and Limelight spa models from 2006 through 2014 It is used to turn on and off the bar top Amur water feature that runs off one of the jet pumps in the spa This valve turns 270 degrees, for 2014 tubs, please ...read more -
Sku: 73356
On/Off Valve Insert
This insert is used on the on/off valve for the soothing stream fountain used on certain Hotsprings spas between 2003-2009 This valve should be replaced if the fountain will not turn off completely when the valve is closed -
Sku: 73351
On/Off Valve .75
This on/off valve is used on Hotsprings spas to turn on and off the Soothing Stream water feature, which runs off the 24-hour circulation pump If the valve fails to shut off the water supply, remove the black internal section from the valve body, and ...read more -
This Coastal Gray On/Off Valve is used for the water feature on Hot Spot and Limelight tubs This valve turns 90 degrees, for 2014 tubs, please verify how far your existing valve turns If it turns 90 degrees, this is the correct replacement If your existing ...read more
-
Sku: 73350
On/Off Valve, Water Feature, 1.5in
This valve is used to turn on and off the Bella Fontana Water Feature in Hotspring Spas and the Amur Water Feature in Tiger River Spas -
Sku: 73327
On/Off Valve Handle Warm Gray
This warm grey handle was used on all water feature valves on Hotsprings and Tiger River spas from 2003 to 2009 that used warm grey jets and handles -
Sku: 70425
Bypass Tee
This assembly is found on all Tiger River spas This 3/4" x 1/2" tee has 3/4" male barbed fittings on each end and a 1/2" barbed male fitting on the elbow It is located in front of the circulation pump between the check valve (35233) and the inlet of the ...read more -
Sku: 30490
Wallfitting, Rear
This fitting is used on many different Hot Spring spa models in various places including the grill style filter compartment as part of the filter assembly Also used in the filter compartment of all 1992-1996 Tiger River spa models -
Barbed tee 1/4" on all three sides Used with 1/4" vinyl tubing and 1/4" clamps
-
This threaded wall fitting is located in the bottom of the filter compartment on all 1997-2010 Tiger River Bengal, Caspian, Sumatran & Siberian spa models This is where the filter standpipe screws into
-
Sku: 31487
Tee, 1/2in X 1/2in Barb
Tee, Barbed, Black Poly, 1/2" x 1/2" x 1/2" -
Sku: 30626
Tee, 1/2in Slip X Slip X Slip
This PVC tee will accept 1/2" male rigid or flexible PVC pipe or male PVC fittings 1/2" schedule 40 thick-walled clear vinyl PVC can also be glued directly to this fitting PVC primer and cement should be used on this fitting Failing to use primer ...read more -
Sku: 34458
Red Tee 2in X 1-1/2in X 1-1/2in
PVC tee, 2" X 1-1/2" X 1-1/2" slip -
Sku: 72185
Diverter valve Tee
Tee for 2 position diverter valve -
Sku: 32465
Tee 2in
This tee allows three 2" male PVC slip connections, or 2" PVC pipe (rigid or flexible) to be joined together, one of which is perpendicular to the other two connections PVC primer and glue should be used to adhere to the male connections tog the fitting -
Sku: 71128
Wallfitting, Drain Drilled
Wall fitting, rear drain, 1/2" drilled, Hot Spring Rear wall fitting located in the footwell of the spa Front wall fitting part 30488 -
Sku: 73482
On and Off Valve, .75
This valve is used for the fountains on certain 2004 only Hot Springs spas The handle and body supplied are not used You should use the body that is mounted in the spa, and the bezel and handle that came with the spa as well -
Sku: 34751
Tee 3/4in Slip X Slip X Slip
This is a regular 3/4"Slip x 3/4" Slip x 3/4" Slip pvc fitting available at most hardware stores -
Sku: 32467
Elbow, 45 Degree 2in
This elbow is used to join two 2" male PVC slip fittings or 2" PVC rigid or flex pipes together at a 45 degree angle PVC primer and cement should be used to secure this fitting to the fittings it is joining together -
This PVC tee has three connections The two connections opposite each other are 2" slip connections, able to accept a 2" PVC pipe, or a 2" male PVC slip fitting The other connection, perpendicular to the other connections accepts a 1 1/2" PVC pipe or ...read more
-
Sku: 30627
Tee, 1in Slip X Slip X Slip
This Tee accepts three 1 inch PVC pipe connections or male PVC fittings All connections should be made using both PVC primer and PVC cement The connections are oriented in a T style layout -
Sku: 36975
Red Tee, 3/4in X 1/2in X 1/2in
Tee, PVC, 3/4" X 1/2" X 1/2" -
Sku: 30638
Tee, 2in X 2in X 1in Slip X Slip X Slip
This PVC tee has three connections The two connections opposite each other are 2" slip connections, able to accept a 2" PVC pipe, or a 2" male PVC slip fitting The other connection, perpendicular to the other connections accepts a 1" PVC pipe or male ...read more -
This PVC tee has three connections The two connections opposite each other are 1 1/2" slip connections, able to accept a 1 1/2" PVC pipe, or a 1 1/2" male PVC slip fitting The other connection, perpendicular to the other connections accepts a 1/2" PVC ...read more
-
This PVC tee has three connections The two connections opposite each other are 2" slip connections, able to accept a 2" PVC pipe, or a 2" male PVC slip fitting The other connection, perpendicular to the other connections accepts a 3/4" PVC pipe or male ...read more
-
Sku: 71263
Wallfitting, Gray, without Knockout
Gray wallfitting, for Hot Spring -
Sku: 33320
Tee, Valve Drain 1/2in X 1/2in Barb
Used on Tiger River drain assemblies, check your serial number in the parts finder above to be sure this part is for your spa -
Sku: 30630
Tee, 1in X 3/4in X 3/4in Slip Connection
Tee, 1" x 3/4" x 3/4", slip connection
Showing 1–30 of 63 results