PLUMBING

Find all the plumbing parts you need here. Flexi PVC tubing, Vinyl Tubing, Elbows, Tees, Diverter Valves, Levers & Bezels, Check-Valves, Couplers, and more.

Plumbing: Cap, Inlet, Jet Face, Plug, Union

Showing 1–30 of 48 results

  • Cap, Drain Valve - 3/4in with Washer
    Black 3/4" hose bib thread cap used on the drains of 1993 forward Hot Spring, Tiger River, Hot Spot, and Solana, and Limelight spa models   It also includes the washer   This cap is used both on the "Primary" Drain Valve, and the "Secondary" Drain Valve
    $1.70
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $6.36
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $3.26
    Add to cart
  • Drain Plug, Wavemaster
    This drain plug is screwed into the female port on the front of Wavemaster 3000, Wavemaster 4000 and 6000 jet pumps when there is an absence of a bleedline   For spas with a bleedline, the 32267 is used in place of this fitting This drain plug can be ...read more
    $2.93
    Add to cart
  • Sweep Pump Union, 2in Soc. 90 Degree
    Two-inch SOC 90deg sweep pump union
    $11.07
    Add to cart
  • Pump Union, 45 Degree
    Pump union (aka compression fitting) can be used to connect to any Wavemaster pump later than 1996   This union accepts a 2" PVC pipe and will attach to a 2" standard pump thread   The fitting for the pipe is at a 45-degree angle
    $10.09
    Add to cart
  • Manifold Plug, 3/4in Slip X 1/4in closed nipple
    This plug has been used on the 220volt pre-1995 Hot Spring heater to cap off the drain hose by clamping the 1/4" vinyl drain tubing to the closed 1/4" nipple on this plug Also used in the 71557-BYP Kit
    $10.96
    Add to cart
  • Cap, Air Control, Jet Selector, Gray
    This gray cap fits on the top of the air control lever to hide the stainless steel screw This cap is also used on the water diverter levers (Smart Jet Selector) white on white spas and gray on all other colored spa shells
    $1.52
    Add to cart
  • Cap, Air Control/Jet Selector, White
    This white cap fits on the top of the 1993-2003 Hot Spring Comfort Control air lever to identify it as the Comfort Control Lever for the Moto-Massage Jet on white-colored Hot Spring models only Note: Also used as an upgrade for the colored dots (sticker) ...read more
    $6.84
    Add to cart
  • 449-020 2in Plug
    This is a 2" PVC plug   It can be used to plug any 2" female PVC fitting and should be installed using PVC primer and cement   You can get PVC cement at your local hardware store
    $4.69
    Add to cart
  • Bezel, Bellafontana Water Feature, Set of 3, Cool Gray, Hot Spring
    This is the cool grey set of 3 bezels for the BellaFontana water feature used in certain Hot Springs spa models beginning in 2023   Three of these are included in the kit   One is used on each stream of the fountain GRANDEE, ENVOY, VANGUARD, ARIA, ...read more
    $13.00
    Add to cart
  • Cap, Lever/Bezel, Quarite Teal
    Lever cap in teal
    $1.74
    Add to cart
  • Street Elbow, 2in, 45 Degree, Spigot X Slip
    Drain valve black cap, washer and ring assembly used on 2004 forward Hot Spring and Tiger River spa models
    $19.86
    Add to cart
  • Cap, Air Valve Lever, Taupe
    Plug, PVC, 3/4" Spig   This plug is made out of PVC and fits in a female PVC slip fitting   It can be used to plug an extra port on a manifold or tee that is not needed   Or cap off a piece of plumbing that is no longer used
    $5.05
    Add to cart
  • Ribbon for Spa Waterfall, No Light
    This is the cool grey Hot Spring Jet escutcheon set for the Bella Fontana water feature used in certain Hot Springs spa models from 2004 to 2013   Three of these are included in this kit; one for each stream GE clear silicone is used on the backside to hold ...read more
    $45.79
    Add to cart
  • Elbow/Union Assembly, Hot Spot
    This assembly is used in two places on the 1993-1994 Hot Spot equipment compartment One of these assemblies connects onto the discharge (top) of the Wavemaster 3000 jet pump and the other end connects onto one side of the heater The second place is on the ...read more
    $45.58
    Add to cart
  • Elbow, 3/4in Poly Barbed
    The three pieces of this pump inlet assembly come pre-assembled and include the check valve This assembly was used on the jet pump on the 1989-1990 Hot Spring Grandee (G 191001 to G 109999)
    $51.10
    Add to cart
  • Elbow, 3/4in Poly Barbed
    The four pieces of this pump inlet assembly come pre-assembled and include the check valve This assembly was used on the jet pump on the 1989 Hot Spring Jetsetter, Prodigy, and Sovereign Also used on the 1991-1992 Grandee
    $75.72
    Add to cart
  • Jet, Duo Blaster Grill Face
    Steel Blue lever cap
    $1.52
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This PVC fitting is used to plug 1 1/2" female PVC slip fittings   It should be attached using PVC primer and cement, which is available at your local hardware store   It is made out of white PVC plastic
    $14.63
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a 1" PVC plug   It is used to plug a 1" female PVC fitting and should be attached using PVC cement and PVC primer   This will usually be used when a fitting has multiple openings, and not all of the openings are being used
    $5.74
    Add to cart
  • Plug 1/2in Spig
    Plug, PVC, 1/2" Spig
    $5.54
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap that can be used to cap off a 2" male slip fitting or a 2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $3.08
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap which can be used to cap off a 1 1/2" male slip fitting or a 1 1/2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $5.56
    Add to cart
  • Union, 1-1/2in Slip x Threaded
    Union, 1-1/2in slip x threaded
    $5.86
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This black hole plug is used on most Hot Spot spas to plug unused holes provided for electrical conduit   Usually, there are two holes predrilled, so that the conduit can enter the equipment compartment of the spa from either side   This plug is used to ...read more
    $1.39
    Add to cart
  • Waterfall Bezel, Gray
    This bezel in Harbor Gray color is used around the waterfall (beauty ring) on Limelight spas 2018 and newer
    $12.68
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    3-port end cap for a 3-port manifold
    $3.09
    Add to cart
  • Ribbon for Spa Waterfall, No Light
    OBSOLETE This Taupe Colored Cap is used on the 2002-2003 Hot Spring Air Control Valves
  • Adapter, Union 1-1/2in
    Used on the 30215 Starite Jet pump   This adapter screws into the 1 1/2" FPT fitting on the jet pump and accepts the union used on spas that use the 30215 jet pump in the early 90s   This piece will only work with the original union   If the union has been ...read more
    $26.58
    Add to cart

Showing 1–30 of 48 results