Plumbing Fittings

Plumbing: Cap, On Off Valve, Plug, Union, Wallfitting

Showing 1–30 of 42 results

  • Cap, Drain Valve - 3/4in with Washer
    Black 3/4" hose bib thread cap used on the drains of 1993 forward Hot Spring, Tiger River, Hot Spot, and Solana, and Limelight spa models   It also includes the washer   This cap is used both on the "Primary" Drain Valve, and the "Secondary" Drain Valve
    $1.70
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $6.36
    Add to cart
  • Compression Fitting O-ring, for 1-1/2 inch Union
    1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps   This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump   No Teflon tape is needed for the jet pump ...read more
    $3.26
    Add to cart
  • Drain Plug, Wavemaster
    This drain plug is screwed into the female port on the front of Wavemaster 3000, Wavemaster 4000 and 6000 jet pumps when there is an absence of a bleedline   For spas with a bleedline, the 32267 is used in place of this fitting This drain plug can be ...read more
    $2.93
    Add to cart
  • Sweep Pump Union, 2in Soc. 90 Degree
    Two-inch SOC 90deg sweep pump union
    $11.07
    Add to cart
  • Pump Union, 45 Degree
    Pump union (aka compression fitting) can be used to connect to any Wavemaster pump later than 1996   This union accepts a 2" PVC pipe and will attach to a 2" standard pump thread   The fitting for the pipe is at a 45-degree angle
    $10.09
    Add to cart
  • Manifold Plug, 3/4in Slip X 1/4in closed nipple
    This plug has been used on the 220volt pre-1995 Hot Spring heater to cap off the drain hose by clamping the 1/4" vinyl drain tubing to the closed 1/4" nipple on this plug Also used in the 71557-BYP Kit
    $10.96
    Add to cart
  • Water Feature On-Off Valve Assembly
    This on-off valve assembly is found on Hot Spot and Limelight spa models from 2006 through 2014 It is used to turn on and off the bar top Amur water feature that runs off one of the jet pumps in the spa This valve turns 270 degrees, for 2014 tubs, please ...read more
    $51.30
    Add to cart
  • 449-020 2in Plug
    This is a 2" PVC plug   It can be used to plug any 2" female PVC fitting and should be installed using PVC primer and cement   You can get PVC cement at your local hardware store
    $4.69
    Add to cart
  • Wallfitting, Rear
    This fitting is used on many different Hot Spring spa models in various places including the grill style filter compartment as part of the filter assembly Also used in the filter compartment of all 1992-1996 Tiger River spa models
    $21.92
    Add to cart
  • Street Elbow, 2in, 45 Degree, Spigot X Slip
    Drain valve black cap, washer and ring assembly used on 2004 forward Hot Spring and Tiger River spa models
    $19.86
    Add to cart
  • Wallfitting without Knockout, Tiger River
    This threaded wall fitting is located in the bottom of the filter compartment on all 1997-2010 Tiger River Bengal, Caspian, Sumatran & Siberian spa models This is where the filter standpipe screws into
    $15.37
    Add to cart
  • Manifold, Flow Cone
    Wall fitting, rear drain, 1/2" drilled, Hot Spring   Rear wall fitting located in the footwell of the spa   Front wall fitting part 30488
    $19.31
    Add to cart
  • Cap, Air Valve Lever, Taupe
    Plug, PVC, 3/4" Spig   This plug is made out of PVC and fits in a female PVC slip fitting   It can be used to plug an extra port on a manifold or tee that is not needed   Or cap off a piece of plumbing that is no longer used
    $5.05
    Add to cart
  • Elbow/Union Assembly, Hot Spot
    This assembly is used in two places on the 1993-1994 Hot Spot equipment compartment One of these assemblies connects onto the discharge (top) of the Wavemaster 3000 jet pump and the other end connects onto one side of the heater The second place is on the ...read more
    $45.58
    Add to cart
  • Elbow, 3/4in Poly Barbed
    Gray wallfitting, for Hot Spring
    $19.55
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This PVC fitting is used to plug 1 1/2" female PVC slip fittings   It should be attached using PVC primer and cement, which is available at your local hardware store   It is made out of white PVC plastic
    $14.63
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a 1" PVC plug   It is used to plug a 1" female PVC fitting and should be attached using PVC cement and PVC primer   This will usually be used when a fitting has multiple openings, and not all of the openings are being used
    $5.74
    Add to cart
  • Plug 1/2in Spig
    Plug, PVC, 1/2" Spig
    $5.54
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap that can be used to cap off a 2" male slip fitting or a 2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $3.08
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap which can be used to cap off a 1 1/2" male slip fitting or a 1 1/2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $5.56
    Add to cart
  • Union, 1-1/2in Slip x Threaded
    Union, 1-1/2in slip x threaded
    $5.86
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This black hole plug is used on most Hot Spot spas to plug unused holes provided for electrical conduit   Usually, there are two holes predrilled, so that the conduit can enter the equipment compartment of the spa from either side   This plug is used to ...read more
    $1.39
    Add to cart
  • Wallfitting, Drain Modified
    Wallfitting, drain modified
    $15.52
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    3-port end cap for a 3-port manifold
    $3.09
    Add to cart
  • Wallfitting Rear, Drain, Hot Spring
    Sku: 35911

    Wallfitting Rear, Drain, Hot Spring

    This item is obsolete and replaced by:
    71128
    This rear wall fitting is found on the backside of the spa shell and attached to the drain plumbing It has a front wall fitting (30488) and o-ring (30482) that screws into it from the front side of the spa shell The front wall fitting has a female 1-1/2" ...read more
  • Adapter, Union 1-1/2in
    Used on the 30215 Starite Jet pump   This adapter screws into the 1 1/2" FPT fitting on the jet pump and accepts the union used on spas that use the 30215 jet pump in the early 90s   This piece will only work with the original union   If the union has been ...read more
    $26.58
    Add to cart
  • Rear Venturi Wallfitting
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Rear wallfitting for the Hydro-Air jet used in all Hot Springs models in 1990 and 1991
  • Plug, Drain Slide 1-1/2in
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com 1-1/2' male threaded PVC plug Available at most hardware stores in various forms
  • Plug, Freeze Pump
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com This plug is used to close off the threaded fittings that are built into most jet pump volutes   These ...read more

Showing 1–30 of 42 results