The team at Backyardplus.com are the best for anything Hot Springs. Super friendly and knowledgeable.On 06/05/2024 by S. O. (verified customer)
Plumbing: Clamp, Seal, Shaft Seal, Union
Showing all 24 results
-
Sku: SK-WM-7000-V3-BYPComplete Seal Kit, Wavemaster 7000 (ver.3)
Wet End Seal Kit for the Wavemaster 7000 (ver 3) Jet Pump These parts only fit the pumps with a vendor number ending in 4081 All the replacement parts necessary when opening up the "wet end" to cure a leaking pump Since the impeller typically breaks when ...read more -
The shaft seal kit is used to prevent water from leaking from around the rotating pump shaft This seal kit is used on most of the Watkins Wavemaster jet pumps and after-market jet pumps Please find your pump model number and if your pump is an OEM ...read more -
The shaft seal kit is used to prevent water from leaking from around the rotating pump shaft This seal kit is used on most of the Watkins Wavemaster jet pumps and after-market jet pumps manufactured by LX (Lingxiao) Please find your pump model number and ...read more -
Sku: 36675-01SSShaft Seal, Watkins Wavemaster 7000 Jet Pump, Vico Ultimax
The shaft seal kit is used to prevent water from leaking from around the rotating pump shaft This shaft seal will only work with the Vico brand wet end An indicator that your Watkins Wavemaster jet pump was made by Vico is the model number will end in "-01" ...read more -
Sku: 30237-x2-BYPCompression Fitting O-ring, for 1-1/2 inch Union (Qty. of 2)
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more -
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more
-
Sku: 301488Sweep Pump Union, 2in Soc. 90 Degree
Two-inch SOC 90deg sweep pump union -
Sku: 1119401Pump Union, 45 Degree
Pump union (aka compression fitting) can be used to connect to any Wavemaster pump later than 1996 This union accepts a 2" PVC pipe and will attach to a 2" standard pump thread The fitting for the pipe is at a 45-degree angle -
Sku: 70032-BYPSeal Plate Kit, Starite- After Market
This after-market (Sta-rite) seal plate is the part of the "wet end" that bolts onto the pump motor This seal plate is the replacement for both the 1hp and 2hp Starite Max-E-Glas jet pumps used on Hot Spring models prior to 1993 Please note, the pump ...read more -
Sku: 70400-BYPShaft Seal, Wavemaster 7000 (v.1)
This shaft seal is for the Wavemaster 7000 (v 1) Sta-rite 5/8" shaft seal used on the 1HP and 2HP jet pumps that were built from 1998 forward This seal is used with the seal plate that DOES NOT require the copper heater sink If you are repairing a pump ...read more -
Sku: 30224Starite Shaft Seal
Sta-rite shaft seal used on the 1HP and 2HP jet pumps that use a copper heat sink on Hot Spring spas Reference number: U109-93SS -
This is the after-market 3/4" Replacement Shaft Seal for the Wavemaster 7000 version 2 and the Wavemaster 9000 -
Sku: 71030Shaft Seal, Wavemaster 7000 (version 2) and 9000
This item is obsolete and replaced by:
71030-BYPReplacement Shaft Seal for the Wavemaster 7000 version 2 and the Wavemaster 9000 See item 71030-BYP for after-market shaft seal -
Sku: Ceramic-Disk-BYPCeramic Pump Seal Disk
This ceramic piece is part of most pump seal kits -
Sku: 30549Union, 1-1/2in Slip x Threaded
Union, 1-1/2in slip x threaded -
Sku: 71448-BYP3/4″ Shaft Seal
3/4" Shaft seal for Wave Master pumps Please call one of our technicians before ordering this part to ensure it is the correct replacement for your jet pump -
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com The V Clamp is a large stainless steel band that holds together the two halves (suction cover & seal ...read more -
Sku: 35282Union Riser, Wavemaster 7000, V2
Obsolete: No factory suggested replacement available at this time Please contact our technicians at (805) 541-9000 or wizard@backyardplus com for advice Union riser is located on the suction & discharge of the Wavemaster 7000 version 2 This fitting ...read more -
Sku: 30257Shaft Seal, 5/8in
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com -
Sku: 30256Seal, Eye
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com -
Use the 70400-BYP This shaft seal is for the Wavemaster 7000 (v 1) -
Sku: 30300Union Assembly, Hayword Pump
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com This union assembly is used for Hayward pumps The threads on this union are slightly finer than ...read more -
Sku: 71562
Shaft Ext 92520100
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Shaft Ext 92520100 -
Sku: 71726
Shaft Seal, Vico Ppufsealviton
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Shaft Seal, Vico Ppufsealviton
Showing all 24 results