Description
What’s included: Impeller, shaft seal, wear ring, volute o-ring, and two compression fitting o-rings. Wet End Seal Kit for the Wavemaster 7000 (ver.3) Gecko Vendor #4081 Jet Pump. All the replacement parts necessary when opening up the “wet end” to cure a leaking pump. Since the impeller typically breaks when removing it to replace the shaft seal, we have included it in this kit.
Please Note:
Warning: If your current impeller is not black but gray or a tan color then this kit is NOT for you. Please verify the Vendor Code on your specific pump. The Vendor code can be found on the sticker on the pump motor. The Wavemaster 7000 (ver.3) non-black impeller, the wear ring, and volute o-ring are not available separately for pumps with a Vendor Code of 3536. There is an alternative solution by replacing the entire “Wet End” with a “Wet End Kit” that will attach to your existing motor and marry up to the suction and discharge fittings on your spa.
Important information for replacement parts:
The manufacturer used several vendors for the wet end side of the 36675 (WM 7000 v.3) Jet pump. If your pump does not have a vendor number on it at all, please call 805-541-9000 or text us photos of your pump’s labels so we can help identify which “wet end” will work with your pump. Please check vendor code on your pump before ordering replacement parts.
*Stamped on volute: GF30 & B653-11
* Stamped on leg of wet end: 92772705
**(Dots: yellow, green)
| Vendor Code: 3861 Model: 36675-02 |
|||
|---|---|---|---|
| Wet End | Impeller | Shaft Seal | Wear Ring |
| Please call 805-541-9000 or text us photos of your pump’s labels | |||
If the vendor code is “3861” or has a “-01, or –02” at the end of the model number, please call 805-541-9000 or text us photos of your pump’s labels or stickers.
Leave feedback about this