Wet End Kit, After Market, 2.0 HP Pump, 48Frame

Item #: 48WUA2HPLX
$72.74

This is the after-market wet end for the LX Brand 2.0HP, 2 Speed jet pump. It has 2″ intake and 2″ discharge and will attach to your existing 48 frame motor.

Note: Measure the diagonal distance of the bolt holes on your pump. If the diagonal measurement is not 5 1/8″ from the center to the center of each hole, then your pump’s frame is 56 frame and this wet end will not fit.

  • Add Free Bleedline Nipple? (32267):

  • Add 2 Compression Fitting O-rings?:

  • Add Free Bleedline Nipple? (33732):

View OEM
SKU: 48WUA2HPLX Categories: , Tags: , ,

Description

What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller, and the shaft seal.

Description: This is the after-market wet end for the LX Brand 2.0HP, 2 Speed jet pump. It has 2″ intake and 2″ discharge and will attach to your existing 48 frame motor.

Note #1: To install this kit you will disassemble it then re-assemble it, one piece at a time, onto your existing pump motor. Typical assembly time is two hours for the non-service tech. 

Note #2: After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines.

Note #3: Measure the diagonal distance of the bolt holes on your pump. If the diagonal measurement is not 5 1/8″ from the center to the center of each hole, then your pump’s frame is 56 frame and this wet end will not fit.

Please check the vendor code on your pump before ordering replacement parts. For an example of where to find your vendor code, click here.

Ref #: PP-GF30, B653-11

View compatibility table & diagrams