Wet End Kit, After Market, 3.0 hp Pump (2 HP @ 50hz European Pump), 48 Frame

Sku: 77516-BYP

This is the after-market wet end for the European Wavemaster 2.0 hp (3HP @ 60hz North American) 48 frame jet pump, model number 0965901.

SKU: 77516-BYP Categories: , Tags: , ,


What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller, and the shaft seal.

Description: This is the AFTER-MARKET “wet end” for the Wavemaster® 2.0HP 50hz European pump (3HP @ 60hz North American). This “wet end” will attach to your existing motor. Your Wavemaster  jet pump is comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your “wet end” has cracked since neither the volute (attaches to the motor) or the volute cover (front of the pump) are available individually from the manufacturer.

Installation: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it then re-assemble it one piece at a time onto your existing pump motor. Typical assembly time is two hours for the non-service tech. After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines.

Important information for replacement parts:
Please check the vendor code or pump model on your pump before ordering replacement parts and use the chart to determine the correct wet-end replacement. If your vendor code reads “3536“, contact us with photos of your pump.

Wet-end will work the following pump models: 0965901
Wet End Impeller Shaft Seal Wear Ring
77516-BYP* 77516-SSSO** 71447-BYP 71409-E

*Stamped on wet end leg: 92770705; Stamped on volute cover: 91231605. Sticker label 91041830-000
**77516-SSSO Dots: Silver, silver, silver, orange (use 71409-E wear ring)
If you can’t determine the dots on your impeller, buy the entire wet-end kit. The installation time is about the same.

View Diagrams & Part Compatibility


There are no reviews yet.

Be the first to review “Wet End Kit, After Market, 3.0 hp Pump (2 HP @ 50hz European Pump), 48 Frame”

Your email address will not be published.


You may also like…

Customers also bought...