I would like to express how excellent this company is. I inherited a house with a 2007 Hotspring Aria hot tub. The spa hasn’t been operated in years and when I turned it on, it ran for about 10 minutes and died. I mean dead died. I knew absolutely nothing about hot tubs but with the excellent diagnosis videos, installation videos and superior phone support, I was able to replace the main control board, heater relay board, heater, circulation pump, the ozonator and all associated tubing. This took 4 1/2 hours over two days (I had to watch videos) but the spa runs like new! I had one question regarding the jumper voltage 18 or 12. I spoke with a technician and he was able to answer my question as well as helping me double check the voltages for the components on the relay board. I am handy with electronics and electricity and am comfortable working with 230 volts. Shipping was fast and as expected. I highly recommend BackYardPlus.On 06/28/2024 by F. R. (verified customer)
Find all the plumbing parts you need here. Flexi PVC tubing, Vinyl Tubing, Elbows, Tees, Diverter Valves, Levers & Bezels, Check-Valves, Couplers, and more.
Showing 1–30 of 44 results
-
Sku: 1044101-72228-AM-BYP
Tubing Kit, Del-Ozone-1/4in with Check valve
This 1/4" ID (3/8" OD) ozone-resistant tubing works with UO3 ozone generator It includes an attached 1/4" ozone-resistant check valve, clamps, mounting screws, and new flag terminals This assembly is approx five feet in length Note: There is a small ...read more -
Sku: 1044101-72228-BYP
Tubing Kit, Freshwater III Ozonator-1/4in Tygon/Kynar with Check valve
This 1/4" ID (3/8" OD) Kynar/Tygon ozone-resistant tubing kit comes standard with the Freshwater III Ozonators It is the replacement for all Freshwater 3 ozonators It includes an attached 1/4" ozone-resistant check valve This assembly is approx six feet ...read more -
Sku: 35233
Water Check Valve, 3/4 inch
This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the backflow of water through the circulation pump once the jet pump is activated All water check valves have arrows stamped on the outside to indicate ...read more -
This 2-position (3 and 9 o'clock) Smart Jet Water Diverter Valve Kit is located under the Smart Jet lever on the top lip of the spa Its purpose is to divert water to different jet combinations when you rotate the lever from 3 o'clock to 9 o'clock ...read more
-
This Smart Jet 4-position (3, 6, 9 and 12 o'clock)Water Diverter Valve is located under the Smart Jet lever/dial on the top lip of the spa Its purpose is to divert water to different jet combinations when you rotate the lever Replacement is necessary only ...read more
-
This valve retainer (sometimes called sleeve) is used as a retrofit to update the base of the Smart Jet on the 1998 Hot Spring and Tiger River spa models This will allow the replacement valve levers and bezels to fit since the 1998 valve lever and bezel are ...read more
-
Sku: 30598
Bleedline Nipple, 1/4in, Hot Spring
This nipple is glued into various PVC fittings in various places on Hot Spring, Tiger River, Limelight, Hot Spot and Solana spa models Simply drill out the broken 1/4" barbed fitting with a 19/64" drill bit (only this size drill bit) Then glue this ...read more -
Air check valve for Hot Spring, Tiger River, and Hot Spot spa models This check valve is located in the equipment compartment under the bartop Its primary function is to prevent water from back flowing into the equipment compartment should a hydrotherapy ...read more
-
Two-position cool gray color Smart Jet selector lever & bezel for all 1998 forward Hot Spring & Tiger River spa models that have a two-position Smart Jet diverter valve This upgraded lever & bezel replaces the obsolete 71610 Check your serial ...read more
-
Order this item only if recommended to do so by our techs This modified 4-position Smart Jet Diverter Valve (12, 3, 6 and 9 o'clock positions) is located under the SmartJet lever on the top lip of the spa Its purpose is to divert water to different jet ...read more
-
This diverter valve is located under the diverter lever on the top lip of the spa Its purpose is to divert water to different jet combinations when you rotate the lever or dial Replacement is necessary only if the valve lever becomes too difficult to turn, ...read more
-
Sku: 30237-x2-BYP
Compression Fitting O-ring, for 1-1/2 inch Union (Qty. of 2)
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more -
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more
-
Sku: 1044101
Check Valve (Ozone) Freshwater Ozone, 1/4in O.D.
Over time an Ozonator check valve will breakdown under the harsh conditions of ozone Our OEM check valves have a special diaphragm (Viton) that enables them to last longer than rubber Rubber diaphragms last about a month before the rubber becomes hard -
BACKORDERED WITH THE FACTORY - NO CURRENT ETA This perforated screen (grill) has many small holes to prevent debris from clogging the floor drain This screen simply unscrews from the 1-1/2" threaded floor fitting
-
This air check valve is located in the equipment compartment, up high, under the bar top If a hydrotherapy jet should become obstructed (like when a guest sticks their finger in the jet), this item becomes critical in preventing water from back flowing into ...read more
-
Sku: 72701
Hartford Loop Assembly
This retrofit kit is used to replace the air check valve that was used in some Hot Spring spa models This kit replaces the obsolete 72342 Check your serial number in the parts finder above to be sure this part is for your spa -
This "Jet System" check valve is used on all Hot Spring models and all Tiger River spas This check valve engages when the diverter valve is changed to different positions For convenience, the inside diameter of this check valve is 1-1/2" and the outside ...read more
-
This complete Air Control Valve Assembly is the factory replacement for Hot Spring, Tiger River, Hot Spot, and Limelight spa models
-
Sku: 75146
Safety Suction Grate, Cool Gray
This new style safety suction grate is the replacement for all previous suction grates in all Hot Spring, Tiger River, Solana, and Hot Spot spas This grate screws into the new style safety suction wall fitting -
Warm gray-colored drain screen for Hot Spring and Solana spa models This perforated screen (grill) has many small holes to prevent debris from clogging the floor drain This screen simply unscrews from the 1-1/2" threaded floor fitting
-
Sku: 74958
Safety Suction Wall Fitting
This new style safety suction wall fitting is the replacement for all previous suction wall fittings in all Hot Spring, Tiger River, Solana, and Hot Spot spas The safety suction grate (75146 or 75147 ) screws into this new style safety suction wall fitting -
Sku: 70864
Check Valve, Safety Suction
This check valve's function is to "open" when someone puts their hand over the jet pumps suction fitting within the filter intake This check valve will "open" drawing air into it from the equipment compartment, thereby stopping suction of the jet pump This ...read more -
Drain Valve used on most 2004 and some 2005 Tiger River and Hot Spring spas It is opened by twisting the hose bib counter-clockwise and pulling the bib forward, and then removing the protective cap The cap also served as a way to grip the big Closed by ...read more
-
Sku: 73456
Check Valve, Flow Control
This check valve is plumbed in line with the Bella Fontana and Amur water features in Hotsprings and Tiger River spas to keep the water flow through the fountain the same when the jet pumps are changed from low speed to high speed and vice versa -
This compression fitting (aka pump union, quick disconnect, coupling) is used on the discharge side of the Tiger River Wavemaster Pumps to ensure that the small Silentflo 5000 or 5002 circulation pump pulls water through the filter when the jet pump is off ...read more
-
Sku: 73682
Air Valve Control Body
This valve body was used on Hotspring and Tiger Rivers spas made from 2004 to 2005 It is the part of the air valve that holds the air valve lever assembly and connects the valve to the air supply for the spa -
Sku: 73808
Ozone Restrictor, Freshwater 3
Flow restrictor for the Freshwater III ozone unit used to reduce the ozone order and/or to eliminate any "burping" noise emanating from the spa Simply remove the air filter from your Freshwater unit and attach to this flow restrictor as shown in the picture ...read more -
Sku: 73363
Smart Jet Lever and Bezel, 4-Position, Cool Gray
This item is obsolete and replaced by:
73360Four-position cool gray color Smart Jet selector lever and bezel all Hot Spring & Tiger River spa models that have a four-position diverter valve This upgraded lever & bezel replaces the obsolete 71608 For the 2-position lever & bezel use part ...read more -
Obsolete by factory White no longer available See item 73363 in cool gray This kit consists of the new style Smart Jet Lever and Bezel, 4-position, in white for the 1998-2010 Hot Spring white interior shell colored models In 2009 this item replaced the ...read more
Showing 1–30 of 44 results