I would like to express how excellent this company is. I inherited a house with a 2007 Hotspring Aria hot tub. The spa hasn’t been operated in years and when I turned it on, it ran for about 10 minutes and died. I mean dead died. I knew absolutely nothing about hot tubs but with the excellent diagnosis videos, installation videos and superior phone support, I was able to replace the main control board, heater relay board, heater, circulation pump, the ozonator and all associated tubing. This took 4 1/2 hours over two days (I had to watch videos) but the spa runs like new! I had one question regarding the jumper voltage 18 or 12. I spoke with a technician and he was able to answer my question as well as helping me double check the voltages for the components on the relay board. I am handy with electronics and electricity and am comfortable working with 230 volts. Shipping was fast and as expected. I highly recommend BackYardPlus.On 06/28/2024 by F. R. (verified customer)
Find all the plumbing parts you need here. Flexi PVC tubing, Vinyl Tubing, Elbows, Tees, Diverter Valves, Levers & Bezels, Check-Valves, Couplers, and more.
Showing 1–30 of 48 results
-
Sku: 37297
6 Port Diverter Valve Body
This 6 port diverter valve body is used on the Hot Spring and Tiger River spa models that utilize a four-position valve -
Sku: 73920
Water Feature On-Off Valve Assembly
This on-off valve assembly is found on Hot Spot and Limelight spa models from 2006 through 2014 It is used to turn on and off the bar top Amur water feature that runs off one of the jet pumps in the spa This valve turns 270 degrees, for 2014 tubs, please ...read more -
Sku: 73356
On/Off Valve Insert
This insert is used on the on/off valve for the soothing stream fountain used on certain Hotsprings spas between 2003-2009 This valve should be replaced if the fountain will not turn off completely when the valve is closed -
Sku: 73351
On/Off Valve .75
This on/off valve is used on Hotsprings spas to turn on and off the Soothing Stream water feature, which runs off the 24-hour circulation pump If the valve fails to shut off the water supply, remove the black internal section from the valve body, and ...read more -
This Coastal Gray On/Off Valve is used for the water feature on Hot Spot and Limelight tubs This valve turns 90 degrees, for 2014 tubs, please verify how far your existing valve turns If it turns 90 degrees, this is the correct replacement If your existing ...read more
-
Sku: 73350
On/Off Valve, Water Feature, 1.5in
This valve is used to turn on and off the Bella Fontana Water Feature in Hotspring Spas and the Amur Water Feature in Tiger River Spas -
Sku: 73327
On/Off Valve Handle Warm Gray
This warm grey handle was used on all water feature valves on Hotsprings and Tiger River spas from 2003 to 2009 that used warm grey jets and handles -
This is the cool grey set of 3 bezels for the BellaFontana water feature used in certain Hot Springs spa models beginning in 2023 Three of these are included in the kit One is used on each stream of the fountain GRANDEE, ENVOY, VANGUARD, ARIA, ...read more
-
This is the warm grey escutcheon set for the Bella Fontana water feature used in certain Hot Springs spa models from 2004 to 2013 Three of these are included in the kit One is used on each stream of the fountain
-
Sku: 70189
Drain Valve Gasket, Slide Valve Style
This black 1-1/2" black gasket is found on both sides of the slide handle body 70247 (obsolete) -
Sku: 75123
Gasket, Jet Selector
This gasket is found below the collar on the Hot Spring, Tiger River & Limelight spa models beginning in 2009 Check your serial number in the Parts Finder to be sure this part is for your spa -
Sku: 38429
Water Manifold,1in X 1/2in 4-Port
Water Manifold, 1" x 1/2" 4-port -
Sku: 34338
Manifold, Flow Cone
Manifold, flow cone -
Sku: 73482
On and Off Valve, .75
This valve is used for the fountains on certain 2004 only Hot Springs spas The handle and body supplied are not used You should use the body that is mounted in the spa, and the bezel and handle that came with the spa as well -
Sku: 39704
6-3/4 Port Water Manifold, 2in Slip PVC
PVC water manifold, 2" Slip x 6 Port 3/4" -
Sku: 33370
Gasket, Silicone 2-3/8in Inside Diameter
Silicone gasket, 2 3/8in -
This is the cool grey Hot Spring Jet escutcheon set for the Bella Fontana water feature used in certain Hot Springs spa models from 2004 to 2013 Three of these are included in this kit; one for each stream GE clear silicone is used on the backside to hold ...read more
-
Sku: 39702
Manifold, Water, 2in X 1/2in, 6-Port
PVC water manifold, 2" X 1/2", 6-Port -
Sku: 300042
Manifold, 2 Port, 3/4in X 1/2in X 1/2in
Wye manifold with 3/4" slip inlet to two 1/2" slip outlets Used on Hot Spring, Tiger River, Hot Spot & Solana spa models PVC cement and primer should be used to make the connections to this manifold -
Sku: 301235
Manifold 1.5in X X 1.5in SP X (4)
Manifold, 1 5inch slip by 1 5 SP x 4 -
PVC water manifold, 1-1/2" X 1/2", 6-Port
-
Sku: 1056601
8 Port Manifold, 2-1/2in x 3/4in
This is a manifold with 2-1/2" slip inlet to eight 3/4" slip outlets It can be used with rigid or flexible PVC piping or male PVC slip fittings PVC primer and cement should be used to adhere to the connections -
Sku: 78154
On and Off Valve, 90 Degree
90 degree on and off valve, for Limelight and Hot Spot models -
Sku: 010020
Four Barbed Water Manifold
Four barbed water manifold (MANIFOLD 4 BARB 1INX3/8IN) for Hot Spring, Hot Spot, and Limelight models -
Sku: 010004
Four Port Water Manifold
Four port water manifold for Hot Spring, Hot Spot and Limelight models MANIFOLD 2S/2SP/4-PORT 1/2 -
Sku: 73808
Ozone Restrictor, Freshwater 3
Flow restrictor for the Freshwater III ozone unit used to reduce the ozone order and/or to eliminate any "burping" noise emanating from the spa Simply remove the air filter from your Freshwater unit and attach to this flow restrictor as shown in the picture ...read more -
Sku: 10012
Manifold, 2 Port 1 S 1/2in S X 3/4in
This 2 port manifold is made of white PVC and is used to connect a 1 1/2" PVC pipe, either flexible or rigid, to two 3/4" PVC pipes, also either rigid or flexible The connections should be made using PVC primer and cement -
Sku: 010007
Manifold, 2S x 2S X 1/2″ (4) Port
Water Manifold, 2" x 2" x 1/2" 4-Port -
Sku: 010016
Manifold, 4 Port , 1-1/2″ X 3/4″
Water manifold with 1-1/2" inlet and four 3/4" outlet ports Used in various spa models within the Watkins family Use pvc primer and pvc cement when gluing either flexible or rigid pvc to this manifold -
Sku: 010011
Manifold, Water , 2″ X 2″ X 3/4″ (4 Port)
This manifold allows a 2" PVC pipe, either flexible or rigid, to be split into four 3/4" PVC lines, also either flexible or rigid PVC primer and cement should be used to attach this fitting to the pipes
Showing 1–30 of 48 results