The team at Backyardplus.com are the best for anything Hot Springs. Super friendly and knowledgeable.On 06/05/2024 by S. O. (verified customer)
Plumbing: Compression Fitting, Split Nut, Wallfitting, Water Manifold
Showing 1–30 of 47 results
-
Sku: 34447-x2-BYPCompression Fitting O-rings, for 2 inch Union (Qty of 2)
(Quantity of 2 o-rings) O-rings used on the pumps 2" compression fittings ( 71036 ) found on most Hot Spring, Tiger River, Limelight, Hot Spot and Solana spa models Also used on the replacement "Wet End" pump kits and some heaters The 2" measurement refers ...read more -
O-ring used on the 2" compression fittings (71036) on most Hot Spring, Tiger River, Hot Spot, and Solana spa models The 2" measurement refers to the inner diameter of the most narrow part of the compression fitting/union The o-ring that is included measures ...read more -
Sku: 71036Compression Fitting, 2in with O-Ring
This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction side of most Wavemaster® XP2 or XP2e Series Jet Pumps Other compression fittings are the 71038 and 71037 ...read more -
Sku: 30237-x2-BYPCompression Fitting O-ring, for 1-1/2 inch Union (Qty. of 2)
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more -
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more
-
Sku: 71038Compression Fitting, 1-1/2in with O-Ring
This 1-1/2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction and/or discharge side of FMHP/CP Series Wavemaster® Jet Pumps 2" x 1-1/2" Compression Fitting click ...read more -
This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling 1-1/2" Compression Fitting 2" Compression Fitting -
This heavy-duty fiberglass-reinforced polymer split nut comes in two pieces and is designed to replace compression fitting nuts (aka pump union nuts) that have broken due to vibration, age and finally over-tightening The two halves of this fitting are held ...read more -
Sku: 30490Wallfitting, Rear
This fitting is used on many different Hot Spring spa models in various places including the grill style filter compartment as part of the filter assembly Also used in the filter compartment of all 1992-1996 Tiger River spa models -
This replacement compression fitting split nut (AKA Split Union Nut-2") is used to connect heaters on the 1993-1994 Hot Spot Z, all 1998-current Hot Spot models, Solana models beginning in 2000 and all 1992-1994 Tiger River spas It is designed in two half ...read more -
Sku: 72072-1.5Split Nut for 1.5in Compression Fittings
This 1-1/2" split nut comes in two pieces and is designed to replace compression fitting nuts (aka pump union nuts) that have broken due to vibration, age, and over-tightening The two halves of this fitting are held together by two screws -
This threaded wall fitting is located in the bottom of the filter compartment on all 1997-2010 Tiger River Bengal, Caspian, Sumatran & Siberian spa models This is where the filter standpipe screws into -
Sku: 38429Water Manifold,1in X 1/2in 4-Port
Water Manifold, 1" x 1/2" 4-port -
Sku: 34338Manifold, Flow Cone
Manifold, flow cone -
Sku: 30548Starite Compression Fitting, 1-1/2″
1-1/2" compression coupling assembly (pump union) for all Starite pumps used on Hot Spring spas -
Sku: 71128Wallfitting, Drain Drilled
Wall fitting, rear drain, 1/2" drilled, Hot Spring Rear wall fitting located in the footwell of the spa Front wall fitting part 30488 -
Sku: 397046-3/4 Port Water Manifold, 2in Slip PVC
PVC water manifold, 2" Slip x 6 Port 3/4" -
This compression fitting (aka pump union, quick disconnect, coupling) is used on the discharge side of the Tiger River Wavemaster Pumps to ensure that the small Silentflo 5000 or 5002 circulation pump pulls water through the filter when the jet pump is off ...read more -
Sku: 39702Manifold, Water, 2in X 1/2in, 6-Port
PVC water manifold, 2" X 1/2", 6-Port -
Sku: 71387Fitting, Comp 45 Degree with O-Ring
This is a 2" pump union with a 45 degree offset street fitting It is used to connect the jet pump to the plumbing of the spa and allows the plumbing to come towards the pump from a 45-degree angle It glues into a 2" female PVC slip fitting using PVC ...read more -
Sku: 300042Manifold, 2 Port, 3/4in X 1/2in X 1/2in
Wye manifold with 3/4" slip inlet to two 1/2" slip outlets Used on Hot Spring, Tiger River, Hot Spot & Solana spa models PVC cement and primer should be used to make the connections to this manifold -
Sku: 301235Manifold 1.5in X X 1.5in SP X (4)
Manifold, 1 5inch slip by 1 5 SP x 4 -
PVC water manifold, 1-1/2" X 1/2", 6-Port -
Sku: 71263Wallfitting, Gray, without Knockout
Gray wallfitting, for Hot Spring -
Sku: 10566018 Port Manifold, 2-1/2in x 3/4in
This is a manifold with 2-1/2" slip inlet to eight 3/4" slip outlets It can be used with rigid or flexible PVC piping or male PVC slip fittings PVC primer and cement should be used to adhere to the connections -
Sku: 010020Four Barbed Water Manifold
Four barbed water manifold (MANIFOLD 4 BARB 1INX3/8IN) for Hot Spring, Hot Spot, and Limelight models -
Sku: 010004Four Port Water Manifold
Four port water manifold for Hot Spring, Hot Spot and Limelight models MANIFOLD 2S/2SP/4-PORT 1/2 -
Sku: 10012Manifold, 2 Port 1 S 1/2in S X 3/4in
This 2 port manifold is made of white PVC and is used to connect a 1 1/2" PVC pipe, either flexible or rigid, to two 3/4" PVC pipes, also either rigid or flexible The connections should be made using PVC primer and cement -
Sku: 010007Manifold, 2S x 2S X 1/2″ (4) Port
Water Manifold, 2" x 2" x 1/2" 4-Port -
Sku: 010016Manifold, 4 Port , 1-1/2″ X 3/4″
Water manifold with 1-1/2" inlet and four 3/4" outlet ports Used in various spa models within the Watkins family Use pvc primer and pvc cement when gluing either flexible or rigid pvc to this manifold
Showing 1–30 of 47 results