Description
What’s included: Heater element w/ power cord.
This 1500 watt heater element is the replacement for all 1980-1994 Hot Spring spa models that operated on 115volts. This heater element, located inside of a stainless steel cylinder style housing, is an immersion type heater. If your spa is older than 1989, you will need the cord adapter (30070). A single 1.5 kW heater element is used in 115-volt spas. The same end of the heater element where the power cord is located also has a place (dry well) where to insert the copper probe from the heater hi-limit (heater reset).
Note: This square flanged heater element is secured into the heater body using four nuts and bolts. The o-ring and gasket (included) are used to prevent water from leaking between the heater and heater body. Repair Tip: To widen the screw holes in the gasket, use a 3/16″ bit or screwdriver. Be very careful not to overdo it and rip it into the gasket.
Note#2: There is a thin copper wire that disappears into the end of your existing heater element. DON’T CUT THAT WIRE. It is part of the heater hi-limit (heater reset) probe and it can not be reattached.
Technical Specs: 115 Volt AC, 1.5 kW, 13 Amps
AKA-31225 SIU J98 TH 90646 110V 1500W
TH 34387 110v 1500w
Warranty: Please be advised that the warranty will be void if dry fired or if element shows signs of spa chemistry imbalance
Reference: 12-1464-BC-K
Leave feedback about this