Description
What’s Included: Pump, two compression fittings with o-rings and power cord. **NO VENT SHROUD**
Specs: 1.5 HP (1.0 HP* Operational HP), 2 Speed, 60 Hz, 48 Frame, 230-volt, 1 1/2″ intake/discharge.
Vent Shroud: Per the manufacturer, this pump is designed to be air-cooled and does not need a shroud. You may, however, use your existing shroud.
Description: This replaces the obsolete Wavemaster® 5000 one-horsepower, one-speed pump found on the pre-1997 Hot Spring and Tiger River spa models and will only work on tubs wired for 230v. The obsoleted pump (33980) was a convertible pump. This pump is NOT CONVERTIBLE. For the 115v, use 34677.
Note: This pump does not include the pump shroud, and while the pump can be operated without a shroud (per the pump manufacturer), your existing shroud your existing pump (if equipped) can be installed on this new pump.
Important information for replacement parts:
Please check the model number and markings on your wet end before selecting replacement parts.
After-Market 33980-BYP Model: 02110005-1010 |
|||
---|---|---|---|
Wet End | Impeller | Shaft Seal | Wear Ring |
33980-WETEND* | 70457** | 71447-BYP | 70220 |
*Stamped on volute: 92770501A. Stamped on suction cover: 9123130.
**70457 Dots: orange (use 70220 wear ring)
If you can’t determine the dots on your impeller, buy the entire wet-end kit. The installation time is about the same.
Be the first to review “Pump, Wavemaster 5000 After-Market Replacement, 1.0 HP, 2 Speed, 230-Volt, 60 Hz, 1 1/2″ Intake/Discharge”