Specs: 230v. only, 60hz, 2- speed, 2.0 HP (operational horsepower), 48 frame, 1-1/2″ intake/discharge. Also included are two compression fittings with o-rings and a power cord (not pictured). **NO SHROUD**
Vent Shroud: Per the manufacturer, this pump is designed to be air-cooled and does not need a shroud. You may, however, use your existing shroud.
Important information for replacement parts:
Please check the model number and markings on your wet end before selecting replacement parts.
|Wet End||Impeller||Shaft Seal||Wear Ring|
*Stamped on volute: 92770501-A. Stamped on suction cover: 9123130.
**70972 Dots: blue (use 70220 wear ring)
If you can’t determine the dots on your impeller, buy the entire wet-end kit. The installation time is about the same.