Wet End Kit, Wavemaster 7000 (ver. 3) 1.65 hp Pump

Item #: 72994-OPENBOX
$127.29

Open box items are items that have been returned to our warehouse and cannot be sold as brand new. Items that are returned to us in less than perfect condition are considered open box and may include the following defects:

  • Cosmetic scratches, wear, dents, etc.
  • Items that were energized, but otherwise not defective and in good working order
*All open box items include a 1 year warranty unless otherwise stated.

Please Note: The manufacturer used several vendors for the wet end side of the 36675 (WM 7000 v.3) Jet pump. Use this link to see where to find your pump’s vendor number.  If your pump does not have a vendor number on it at all, please call us, we may request photographs to help identify which wet end will work with your pump.

If your pump has a vendor number of “4081” on it, then this is the correct wet end.  If your pump has a vendor number of “3536” on it, then use part number 77711.

This is the complete “wet end” of the jet pump. The jet pump is comprised of two main components: the electric motor and the “wet end”.

**If your pump has vendor number of “3861”, WE DO NOT HAVE REPLACEMENT PARTS. Please order the complete pump 71699.

SKU: 72994-OPENBOX Categories: , Tags: , ,

Description

What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller and the shaft seal. Also included is the bleedline nipple (item 32267).

Description: This is the complete “wet end” of the jet pump. Your Wavemaster 7000 (v. 3) jet pump is comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your ‘wet end” has cracked due to a severe freeze since neither of the two halves is available individually. If your existing impeller is any color other than black, then you’ll need this “wet end kit” as well. Here’s why. One of the two pump manufacturers, that made this pump for Hot Springs, went out of business taking with them molds for the slightly smaller in diameter impeller. The shaft seal is still available. The front and top of this “wet end kit ” will attach to your existing compression fittings (aka pump union).

Note: Measure the diagonal distance of the bolt holes on your pump. If the diagonal measurement is not 5 1/8″ (5.134″) from the center to the center of each hole, please call us.

Note #2: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it and re-assemble it one piece at a time onto your existing pump motor. The typical assembly time of this kit is two hours for the non-service tech.

Note #3: After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines.

Note #4: Some models may require minor plumbing modifications to connect to the new wet end. Please call our technicians with any questions.

Note #5: If your pump has a vendor of “4081” on it, then this is the correct wet end.  If your pump has a vendor number of “3536” on it, then use part number 77711.

View compatibility table & diagrams