Description
What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller, and the shaft seal. Also included is the bleedline nipple (item 32267) and slinger.
Description: This is the complete “wet end” for the Wavemaster® 9000 & 9200, 2.5HP pump. This “wet end” will attach to your existing motor. It is a 56 frame, 2.5 HP wet end.
Your Wavemaster 9000 & 9200 (v.2), 2.5 HP jet pump is comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your “wet end” has cracked since neither the volute (attaches to the motor) or the volute cover (front of the pump) are available individually from the manufacturer.
Installation: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it then re-assemble it one piece at a time onto your existing pump motor. Typical assembly time is two hours for the non-service tech. After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines.
Important information for replacement parts:
Please check the vendor code or pump model on your pump before ordering replacement parts and use the chart to determine the correct wet-end replacement. If your vendor code reads “4081“, see item 72996.
| Wet end will work the following pump models: 0982601-03 and 39578-03 |
|||
|---|---|---|---|
| Wet End | Impeller | Shaft Seal | Wear Ring |
| 77713* | n/a | 77363 | n/a |
*Stamped on wet-end: PP-GF30; B436-14 (03).
**For volute-oring, see item 56WUA500-V
***If the vendor code is “3861” or has a 39578-01, 0982601-01, 39578-02 or 0982601-02, please call 805-541-9000 or text us photos of your pump’s labels or stickers.
