Description: This 1.0HP impeller is the after-market impeller used on the Wavemaster 4000 LX brand jet pumps. This impeller screws onto the pump motor’s threaded shaft with regular right-hand threads.
Installation: The steps to replace an impeller are very similar to replacing a wet-end kit and take about the same amount of time.
Step 1. Unscrew and Remove the volute cover of the Wet End.
Step 2. Use a pair of plyers to hold the motor shaft while you turn the impeller counterclockwise.
Step 3. Turn the impeller counterclockwise until it is free from the motor shaft.
Step 4. If the spring-loaded part of the shaft seal, or the wear ring is still on the impeller, remove them.
Step 5. To install the new impeller, simply reverse steps 1 – 4.
Important information for replacement parts:
Please check vendor code, horsepower, voltage, and speed on your pump before ordering replacement parts.
|Vendor Code: 3536
Model: 39575-03 or 37334-03
|Wet End||Impeller||Shaft Seal||Wear Ring|
*Stamped on volute: GF30 & B653-11
**For volute-oring, see item 48WUA-V