What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller and the shaft seal.
Description: This is the 1.0 HP after-market wet end for the Wavemaster® 4000 jet pump. This wet end is exclusively for LX model pumps that have a vendor code of “3536”. Your Wavemaster 4000 (1.0 HP) jet pump is comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your ‘wet end” has cracked due to a severe freeze since neither of the two halves are available individually. The shaft seal and impeller are still available.
Installation: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it and re-assemble it one piece at a time onto your existing pump motor. The typical assembly time for this kit is two hours for the non-service tech.
Important information for replacement parts:
Please check vendor code, horsepower, voltage, and speed on your pump before ordering replacement parts.
|Vendor Code: 3536
Model: 39575-03 or 37334-03
|Wet End||Impeller||Shaft Seal||Wear Ring|
*Stamped on volute: GF30 & B653-11
**For volute-oring, see item 48WUA-V