Description: This black impeller is the replacement for the Vico Ultimax version of the Wavemaster 7000, 48 Frame jet pump. It is 1.5HP, not the OEM 1.65HP. This impeller screws onto the pump motor’s threaded shaft with regular right-hand threads.
Installation: The steps to replace an impeller are very similar to replacing a wet-end kit and take about the same amount of time.
Step 1. Unscrew and Remove the volute cover of the Wet End.
Step 2. Use a pair of plyers to hold the motor shaft while you turn the impeller counterclockwise.
Step 3. Turn the impeller counterclockwise until it is free from the motor shaft.
Step 4. If the spring-loaded part of the shaft seal, or the wear ring is still on the impeller, remove them.
Step 5. To install the new impeller, simply reverse steps 1 – 4.
Important information for replacement parts:
Please check the model number on your pump before ordering this part and use the chart to determine the correct wet-end replacement. If your vendor code reads “3536” and model number 36675-03, see item 77711 wet end. If your vendor code reads “4081” and model number 36675, see item 71403 impeller.
|Wet-end will work the following pump models: 36675-01|
|Wet End||Impeller||Shaft Seal|