Description
This is the complete “Wet End” of the Vico Ultimax version of the Watkins Wavemaster 7000 jet pump. This wet end is 1.5 horsepower and the factory original jet pump is 1.65 horsepower. The factory no longer sells Vico replacement parts so the alternative is a new jet pump.
What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, impeller, and the shaft seal.
Description: This is the complete “wet end” of the Vico/Balboa Water Group jet pump. Your pump is comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your “wet end” has cracked due to a severe freeze.
Installation: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it, then re-assemble it one piece at a time onto your existing pump motor. Typical assembly time is two hours for the non-service tech. After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines. Some models may require minor plumbing modifications to connect to the new wet end.
Important information for replacement parts:
Please check the model number on your pump before ordering this part and use the chart to determine the correct wet-end replacement. If your vendor code reads “3536” and model number 36675-03, see item 77711. If your vendor code reads “4081” and model number 36675, see item 72994.
Wet-end will work the following pump models: 36675-01 | |||
---|---|---|---|
Wet End | Impeller | Shaft Seal | |
WE36675-01 | IM36675-01 | 71448-BYP |
Be the first to review “Wet End Kit, Watkins Wavemaster 7000 Jet Pump (ver. 3) 1.5HP, 48Frame, Vico Ultimax”