The team at Backyardplus.com are the best for anything Hot Springs. Super friendly and knowledgeable.On 06/05/2024 by S. O. (verified customer)
Plumbing: Compression Fitting, Drain Valve, Union, Wallfitting
Showing 1–30 of 38 results
-
Sku: 34447-x2-BYPCompression Fitting O-rings, for 2 inch Union (Qty of 2)
(Quantity of 2 o-rings) O-rings used on the pumps 2" compression fittings ( 71036 ) found on most Hot Spring, Tiger River, Limelight, Hot Spot and Solana spa models Also used on the replacement "Wet End" pump kits and some heaters The 2" measurement refers ...read more -
O-ring used on the 2" compression fittings (71036) on most Hot Spring, Tiger River, Hot Spot, and Solana spa models The 2" measurement refers to the inner diameter of the most narrow part of the compression fitting/union The o-ring that is included measures ...read more -
Sku: 71036Compression Fitting, 2in with O-Ring
This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction side of most Wavemaster® XP2 or XP2e Series Jet Pumps Other compression fittings are the 71038 and 71037 ...read more -
Sku: 30237-x2-BYPCompression Fitting O-ring, for 1-1/2 inch Union (Qty. of 2)
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more -
1-1/2" compression coupling (pump union) o ring for some Wavemaster jet pumps and all Starite pumps This o-ring should typically be replaced when removing the jet pump for repair and reinstalling the jet pump No Teflon tape is needed for the jet pump ...read more
-
Sku: 71038Compression Fitting, 1-1/2in with O-Ring
This 1-1/2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling It is found on the suction and/or discharge side of FMHP/CP Series Wavemaster® Jet Pumps 2" x 1-1/2" Compression Fitting click ...read more -
This 2" compression fitting, which includes the o ring, is sometimes referred to as a pump union or compression coupling 1-1/2" Compression Fitting 2" Compression Fitting -
Sku: 301488Sweep Pump Union, 2in Soc. 90 Degree
Two-inch SOC 90deg sweep pump union -
Sku: 1119401Pump Union, 45 Degree
Pump union (aka compression fitting) can be used to connect to any Wavemaster pump later than 1996 This union accepts a 2" PVC pipe and will attach to a 2" standard pump thread The fitting for the pipe is at a 45-degree angle -
This yellow and black drain valve is found on Hot Spring, Tiger River, Hot Spot, and Solana spa models Simply connect your garden hose to the threaded end and turn the black knob and Viola! -
Sku: 30490Wallfitting, Rear
This fitting is used on many different Hot Spring spa models in various places including the grill style filter compartment as part of the filter assembly Also used in the filter compartment of all 1992-1996 Tiger River spa models -
This replacement compression fitting split nut (AKA Split Union Nut-2") is used to connect heaters on the 1993-1994 Hot Spot Z, all 1998-current Hot Spot models, Solana models beginning in 2000 and all 1992-1994 Tiger River spas It is designed in two half ...read more -
This threaded wall fitting is located in the bottom of the filter compartment on all 1997-2010 Tiger River Bengal, Caspian, Sumatran & Siberian spa models This is where the filter standpipe screws into -
Drain Valve used on most 2004 and some 2005 Tiger River and Hot Spring spas It is opened by twisting the hose bib counter-clockwise and pulling the bib forward, and then removing the protective cap The cap also served as a way to grip the big Closed by ...read more -
Sku: 30548Starite Compression Fitting, 1-1/2″
1-1/2" compression coupling assembly (pump union) for all Starite pumps used on Hot Spring spas -
Sku: 71128Wallfitting, Drain Drilled
Wall fitting, rear drain, 1/2" drilled, Hot Spring Rear wall fitting located in the footwell of the spa Front wall fitting part 30488 -
This compression fitting (aka pump union, quick disconnect, coupling) is used on the discharge side of the Tiger River Wavemaster Pumps to ensure that the small Silentflo 5000 or 5002 circulation pump pulls water through the filter when the jet pump is off ...read more -
Sku: 70906Elbow/Union Assembly, Hot Spot
This assembly is used in two places on the 1993-1994 Hot Spot equipment compartment One of these assemblies connects onto the discharge (top) of the Wavemaster 3000 jet pump and the other end connects onto one side of the heater The second place is on the ...read more -
Sku: 71387Fitting, Comp 45 Degree with O-Ring
This is a 2" pump union with a 45 degree offset street fitting It is used to connect the jet pump to the plumbing of the spa and allows the plumbing to come towards the pump from a 45-degree angle It glues into a 2" female PVC slip fitting using PVC ...read more -
Sku: 71263Wallfitting, Gray, without Knockout
Gray wallfitting, for Hot Spring -
Sku: 35046Drain Assembly, Hot Spot
This drain assembly is used on the Wavemaster 3000 and has a 1-1/2" union coupling (compression fitting) on one end, a slip 1-12" PVC fitting and then a 3/4" male hose fitting for draining on the 1995-1996 Hot Spot spa models This assembly connects onto the ...read more -
Sku: 70835Drain Assembly, Hot Spot Z
This drain assembly is used on the Wavemaster 3000 and has a 1-1/2" union coupling (compression fitting) on each end and a 3/4" male hose fitting for draining the 1993-1994 Hot Spot Round (Z model) spa This assembly connects onto the jet pump and the Hot ...read more -
Sku: 30549Union, 1-1/2in Slip x Threaded
Union, 1-1/2in slip x threaded -
Sku: 71117
Wallfitting, Drain Modified
Wallfitting, drain modified -
This rear wall fitting is found on the backside of the spa shell and attached to the drain plumbing It has a front wall fitting (30488) and o-ring (30482) that screws into it from the front side of the spa shell The front wall fitting has a female 1-1/2" ...read more -
Sku: 33937Drain Valve, Hot Spring
This white drain valve was used on all 1993-2001 Hot Spring spa models The original had a black turn knob on top of the gate valve and this replacement has a red handle -
Sku: 30552Adapter, Union 1-1/2in
Used on the 30215 Starite Jet pump This adapter screws into the 1 1/2" FPT fitting on the jet pump and accepts the union used on spas that use the 30215 jet pump in the early 90s This piece will only work with the original union If the union has been ...read more -
Sku: 10430Rear Venturi Wallfitting
Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Rear wallfitting for the Hydro-Air jet used in all Hot Springs models in 1990 and 1991 -
Sku: 70246Handle, Slide Drain
OBSOLETE This handle is used on the drain valve for Hotspring spas manufactured from 1990 to 1992 It's a gate style valve that is pulled up vertically to open and pushed down to close The valve is made up of a few components that can be replaced when ...read more -
Sku: 70247Drain Valve Handle, Slide Valve Style
Obsolete: No factory suggested replacement available at this time Please contact our technicians at (805) 541-9000 or wizard@backyardplus com for advice This drain valve body has a T shaped white handle that is pulled upwards when it's time to drain the ...read more
Showing 1–30 of 38 results