Plumbing Fittings

Plumbing: Cap, Check Valve, Wallfitting

Showing all 27 results

  • Cap, Drain Valve - 3/4in with Washer
    Black 3/4" hose bib thread cap used on the drains of 1993 forward Hot Spring, Tiger River, Hot Spot, and Solana, and Limelight spa models   It also includes the washer   This cap is used both on the "Primary" Drain Valve, and the "Secondary" Drain Valve
    $1.70
    Add to cart
  • Hartford Loop Assembly
    This retrofit kit is used to replace the air check valve that was used in some Hot Spring spa models This kit replaces the obsolete 72342 Check your serial number in the parts finder above to be sure this part is for your spa
    $71.07
    Add to cart
  • Wallfitting, Rear
    This fitting is used on many different Hot Spring spa models in various places including the grill style filter compartment as part of the filter assembly Also used in the filter compartment of all 1992-1996 Tiger River spa models
    $21.92
    Add to cart
  • Check Valve, Safety Suction
    This check valve's function is to "open" when someone puts their hand over the jet pumps suction fitting within the filter intake This check valve will "open" drawing air into it from the equipment compartment, thereby stopping suction of the jet pump This ...read more
    $43.01
    Add to cart
  • Street Elbow, 2in, 45 Degree, Spigot X Slip
    Drain valve black cap, washer and ring assembly used on 2004 forward Hot Spring and Tiger River spa models
    $19.86
    Add to cart
  • Wallfitting without Knockout, Tiger River
    This threaded wall fitting is located in the bottom of the filter compartment on all 1997-2010 Tiger River Bengal, Caspian, Sumatran & Siberian spa models This is where the filter standpipe screws into
    $15.37
    Add to cart
  • Manifold, Flow Cone
    Wall fitting, rear drain, 1/2" drilled, Hot Spring   Rear wall fitting located in the footwell of the spa   Front wall fitting part 30488
    $19.31
    Add to cart
  • Compression Fitting with Check Valve, Tiger River
    This compression fitting (aka pump union, quick disconnect, coupling) is used on the discharge side of the Tiger River Wavemaster Pumps to ensure that the small Silentflo 5000 or 5002 circulation pump pulls water through the filter when the jet pump is off ...read more
    $48.62
    Add to cart
  • Elbow, 3/4in Poly Barbed
    The four pieces of this pump inlet assembly come pre-assembled and include the check valve This assembly was used on the jet pump on the 1989 Hot Spring Jetsetter, Prodigy, and Sovereign Also used on the 1991-1992 Grandee
    $75.72
    Add to cart
  • Elbow, 3/4in Poly Barbed
    Gray wallfitting, for Hot Spring
    $19.55
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap that can be used to cap off a 2" male slip fitting or a 2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $3.08
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    This is a cap which can be used to cap off a 1 1/2" male slip fitting or a 1 1/2" PVC pipe, either rigid or flexible   PVC primer and PVC cement should be used to attach this fitting
    $5.56
    Add to cart
  • Wallfitting, Drain Modified
    Wallfitting, drain modified
    $15.52
    Add to cart
  • Pump, Wavemaster 5000 1.5HP V2
    3-port end cap for a 3-port manifold
    $3.09
    Add to cart
  • 3/4 IN Check Valve
    3/4" check valve found on many Hot Spring models beginning in 2007, Hot Spot beginning in 2019, and Limelight models beginning in 2019
    $16.50
    Add to cart
  • Wallfitting Rear, Drain, Hot Spring
    Sku: 35911

    Wallfitting Rear, Drain, Hot Spring

    This item is obsolete and replaced by:
    71128
    This rear wall fitting is found on the backside of the spa shell and attached to the drain plumbing It has a front wall fitting (30488) and o-ring (30482) that screws into it from the front side of the spa shell The front wall fitting has a female 1-1/2" ...read more
  • Rear Venturi Wallfitting
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Rear wallfitting for the Hydro-Air jet used in all Hot Springs models in 1990 and 1991
  • Cap Suction Warm Gray
    Sku: 73550

    Cap Suction Warm Gray

    This item is obsolete and replaced by:
    75147
    OBSOLETE, use 75147 This suction cap is used on Solana spas covering the water intake in the footwell of the spa   It helps prevent the intake from being completely covered and also prevents large debris from getting sucked into the jet pump
  • Wallfitting, Pvc Rear
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com  
  • Suction Cap, Taupe, Solana
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com
  • Cap Suction Fitting 2in 100Gpm
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com
  • Wallfitting, Front 1-1/2in
    Obsolete: Factory replacement suggestion item #74958 and 75146 Used in the 2001-2008 Tiger River & Solana spas The suction fitting style has been updated to 2009 standards and requires the 74958 wall fitting and the 75146 or 75147 grate
  • Front Wallfitting, Jetstream Jet, Gray
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Gray threaded wall fitting nut inserts through the spa shell and screws into the Jetstream Jet body
  • Wallfittiing #1 Front, Gray Plg
    OBSOLETE-Use 30488
  • Cap Slip 1/2in
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com
  • PVC Cap 1in Slip
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com Cap, PVC, 1" slip
  • Cap 1-1/4in Slip
    Obsolete: No factory suggested replacement available at this time Please contact our technicians for advice (805) 541-9000 or wizard@backyardplus com This is a cap that can be used to cap off a 1 1/4" male slip fitting or a 1 1/4" PVC pipe, either rigid ...read more

Showing all 27 results