Description
What’s Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller, and the shaft seal. Also included are the bleedline nipple (item 32267) and slinger (item 71551).
Description: This is the complete”wet end” for the Wavemaster 8000 2.0 hp jet pump and Wavemaster 8200 2.0hp two-speed jet pump. This “wet end” will attach to your existing motor. Your Wavemaster 8000 v.2, 2 HP jet pump and the Wavemaster 8200 are comprised of two main components: the electric motor and the “wet end”. In some cases, this entire “wet end kit” is needed. Perfect remedy if your “wet end” has cracked due to a severe freeze.
Installation: All “wet end kits” come pre-assembled from the factory. To install this kit you’ll disassemble it then re-assemble it one piece at a time onto your existing pump motor. Typical assembly time is two hours for the non-service tech. After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1″ lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4″ into the floor of the equipment compartment or you may drill into plumbing lines.
Important information for replacement parts:
Please check the vendor code or pump model on your pump before ordering replacement parts and use the chart to determine the correct wet-end replacement. If your vendor code reads “3536“, see item 77712.
Wet-end will work the following pump models: 1019801, 06120500-2040, 39577, and 0982701 (186540-01) (NO VENDOR CODE) | |||
---|---|---|---|
Wet End | Impeller | Shaft Seal | Wear Ring |
72995* | 71405** | 71447-BYP | 71409 |
*Stamped on leg of wet-end 92772705 or 92770705 if you still have your original pump and have never replaced the wet end.
**71405 Dots: blue, blue (use 71409 wear ring)
If you can’t determine the dots on your impeller, buy the entire wet-end kit. The installation time is about the same.
Be the first to review “Wet End Kit, Wavemaster 8000/8200 (ver. 2) 2.0 hp Pump”